West Coast Customs assembled Project B Zero by melding a body from a 1955 Chevrolet Bel Air to a Model 3 platform. It's like a vintage American design paired with a brand new Tesla that kept all its hidden guts intact. The platform architecture remains unmodified so it supports Tesla Superchargers and over the air software updates.
The shop behind Pimp My Ride didn't bother stuffing the electric motor into an old chassis. Instead, the builders kept the entire Model 3 chassis and swapped the panels from the body to the steel from the classic car. Only it wasn't just a simple panel swap. The original wheelbase of the 1955 Chevrolet was 292.1 centimeters, but the Tesla chassis was only 287.5 centimeters. As the Model 3 battery pack lives underneath the floor of the chassis, it couldn't simply extend the lengthening portions of the car without compromising the structure. Instead, the builders widened the rear wheel arches of the Bel Air.
The exterior still shows the original Bel Air paint colour, but it has been made into a matte finish, complemented by gloss black trim. The interior is plainly Tesla, so it still has the normal steering wheel and centre touchscreen. Custom seats are finished in black suede with white octagonal stitching, red highlights and B Zero branding on the dash.
There are also clear advantages to keeping the whole Tesla platform stock. The vehicle uses factory battery cooling systems and original safety equipment, and has the stock powertrain controller. Owners can simply connect to any Tesla Supercharger station and gain over the air software updates as intended.

